• Plasterboard

• Brick 

• Cement sheet 

• Bare timber

• Set plaster 

• Fibrous plaster 

• Plasterglass 

• Concrete

• Masonry

Surface must be clean, dry and free from dust, oils and grease. 

For Cracks or holes with filler: 

• Spot prime repairs with Dulux 1Step® Prep Water Based Primer, Sealer & Undercoat. 

Glossy surfaces: 

• Lightly sand to a dull finish.

Unpainted plasterboard, brick, cement sheet, bare timber:

• One coat of Dulux 1Step® Prep Water Based Primer, Sealer & Undercoat. 

Set plaster, fibrous plaster, plasterglass: 

• One coat of Dulux PRECISION® Sealer Binder.

1. Stir paint thoroughly with a flat paddle using an up-and-down scooping action. 

2. Cut-in around the edges with a brush, then roll up to the border whilst it is still wet. 

3. Apply two coats ensuring that the first coat is completely dry before applying the second.

Do not pour leftover paint down the drain. 

Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz

Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.

Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first. 

Do not reuse container unless thoroughly decontaminated. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz