• New and previously painted surfaces

• Benchtops

• Wall tiles

• Ceramic

• Border tiles 

• Glass bricks

Dulux Renovation Range Tiles & Benchtops requires a clean and primed surface to adhere or the paint will peel and flake off. 

All grease, silicone and dirt contamination must be removed and Dulux Renovation Range Primer must be applied following label directions prior to applying your Renovation Range topcoat.

1. Wash brushes and rollers prior to use. 

2. Remove any loose fibres or hairs. 

3. Cut in as necessary using the recommended brushes. 

4. Coat surface using recommended roller. 

5. Maintain a wet edge during application when brushing and rolling. 

6. Lay off. 

7. Once each section is coated, gently go over the surface in the same direction with minimal paint on the roller using light pressure. 

8. This will give a smooth consistent finish. 

9. Using poor quality or worn rollers can affect the final finish. 

10. Apply two coats of Dulux Renovation Range Clear as the final coat for added protection.

Do not pour leftover paint down the drain. 

Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz

Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.

Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first. 

Do not reuse container unless thoroughly decontaminated. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz