Wear suitable protective clothing, including chemical resistant gloves and eyewear when mixing and applying the product. 

1. Sweep the surface clean. 

2. Pressure wash the surface (use a 1200psi or higher-pressure machine) to remove dirt dust, algae, mould and other contaminants. 

3. Wait for the surface to be free of pooled water.

• Mix the Dulux Concrete and Paving Bare Concrete Etch and Clean into a bucket or watering can at a ratio of 1 part cleaner to 20 parts water. 

• Apply evenly using a plastic watering can, before scrubbing into the surface.  

• Allow Dulux Concrete & Paving Sealed Surface to remain on the surface for 10-15 minutes. Ensure that the surface does not dry out.  

• Power wash the surface to remove all residues released.  

• Allow the cleaned surface to dry.

Do not pour leftover paint down the drain. 

Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz

Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.

Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first. 

Do not reuse container unless thoroughly decontaminated. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz